Joint for Bornemann EH 600 progressing cavity pumps / mono pumps

The joint is pre-assembled and ready to use.

Drawing position: 216

Material: Made of stainless steel. Also available in special versions, e.g. for use in explosive environments. – Please contact us!

Joints have a long life span. However, as with all moving parts, they are wear and tear parts that will wear out over time. Your progressive cavity pump has two joints that wear at approximately the same rate. We recommend replacing both joints at the same time.

A tip from our workshop: You don’t always need new joints! In most cases, it is sufficient to overhaul the joints. Just send us your joints and we will service them for you! We check them for damage, hairline cracks and signs of wear and tear. We replace the bushes, bolts, zyko sleeves and some small parts and fill the joint with new joint grease. This will give your joints a long life again. – This not only helps the environment, but also your wallet.