Spare parts kit: stator + rotor E4H 1900

Contains all the spare parts you will need to replace the stator and the rotor. Suitable for Fludyn BE4H 1900 and ITT-Bornemann* E4H 1900 progressing cavity pumps / mono pumps.

Consisting of:
1x Stator
1x matching Rotor
1x “Mounting Kit Rotor” with small parts

Note: The mounting kit is required to connect the rotor to the coupling rod.

Our recommendation: Depending on the pumped medium (e.g. oils) a rotor may still be in good condition. The Rotor requires less frequent replacement than the Stator. However, purchase both from the same supplier. This ensures that the Stator and Rotor are well-matched.

For complete maintenance, you should also check and, if necessary, replace both joints on the Rotor and the Drive shaft. Also pay attention to the large seal (drawing position: 25) between the pump housing and bearing housing!

Our tip: You can send us your old joints. We will then check and repair them for you. In most cases, this is possible by replacing a few wearing parts. This protects the environment and your wallet!